You can check these easily by removing them and inspecting them for damage. This will cause issues such as the pump not switching on or off to the pump turning on or off at incorrect times. On occasion the two points that are used for setting the “ON” and “OFF” times for the pool pump get damaged or loosen. On/Off Trippers or Pointers Loose or Damaged You can replace the entire mechanism or the gears. If it doesn’t, there could be an issue with the clock face or gears. To check this, try to pull out the clock dial and then move it to the correct time and press it back down again. Yet another reason why timers don’t work properly is the yellow clock wheel is not located or seated properly. Clean the gears with a toothbrush if you see debris or gunk in them. To check this, carefully inspect the gears for missing teeth and make sure they all freely turn. If any of these issues occur your timer will not work properly. Sometimes bugs get in there and jam the gears, sometimes debris is the issue and other times the gears get old and may lose a tooth. The gears in mechanical timers can get damaged. make sure it hasn’t tripped and is switched on. Also known as an RCD (residual current device) in Australia and the UK. Your pool timer and pump will be on its own circuit and have a dedicated circuit breaker or GFCI (ground fault circuit interrupter). The first and easiest thing to check is the circuit breaker.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |